Installation - Isuzu 2000 Trooper Workshop Manual

9J–30
SUPPLEMENTAL RESTRAINT SYSTEM

Installation

1. Connect air bag to wiring harness connector.
NOTE: Pass the lead wire through the tabs on the plastic
cover (wire protector) of air bag to prevent lead wire from
being pinched.
2. Install air bag into steering wheel and tighten bolts to
specified sequence as shown in figure.
Torque: 8 N·m (69 lb in)
CAUTION: Never use the air bag assembly from
another vehicle and difference model year air bag
assembly.
The air bag assembly has identification colors on the
bar code label from '00 model as follows.
Yellow color for driver air bag assembly.
White color for passenger air bag assembly.
Use only new air bag assembly proper to the Trooper
which is being repaired.
3. Enable the SRS (Refer to "Enabling the SRS" in this
section).
827RT009
827RW007