Resetting The Bridge; Restoring The Bridge To Factory Defaults - 3Com WL-560 User Manual

Resetting the
Bridge
Restoring the
Bridge to Factory
Defaults
If the Bridge stops responding correctly, you can perform a reset, which
disrupts the network association temporarily, but does not affect Bridge
configuration settings that have already been applied with Apply.
To reset the Bridge, under Tools, click Reset Wireless Workgroup Bridge.
In the next page, click Reset.
The Bridge can also be reset using the Wireless Infrastructure Device
Manager (Widman). Right-click the Bridge in Widman, and then select
Reset.
You can restore Bridge settings to the defaults that were set at the factory
either manually or through software.
To restore the settings manually, insert a pointed object (such as the end
of a straightened paper clip) into the reset hole on the back of the Bridge,
and hold for five seconds.
The reset hole is accessible with the Bridge in the cradle, as shown in
Figure 16, or with the Bridge out of the cradle.
Figure 16 Manually Resetting the Bridge in the Cradle
RESET RESET
To restore the settings through software:
1 Under Tools, click Restore Factory Defaults.
2 Click Restore.
Reset Hole

Resetting the Bridge

51