Table of Contents
Advertisement
Deciding Where to
Place the Bridge
Wall-Mounting the
Bridge
Place the Bridge in a dry, clean location near the hub, computer, or printer
that will be connected to the Bridge. The location must have a power
source and be within the following distance of a Wi-Fi compliant wireless
LAN access point or ad-hoc wireless station:
For 802.11a compatibility, place the Bridge within 50 m (164 ft) of a
■
Wi-Fi compliant wireless LAN access point.
For 802.11b/g compatibility, place the Bridge within 100 m (328 ft) of
■
a Wi-Fi compliant wireless LAN access point.
The location should be away from transformers, heavy-duty motors,
fluorescent lights, microwave ovens, refrigerators, or other equipment
that could cause radio signal interference.
The Bridge comes with a cradle for mounting on a wall. For additional
security, the Bridge also comes with a locking bar, which can be used with
a security lock (not provided) to lock the Bridge to the cradle after the
Bridge is mounted to a wall.
To wall-mount the bridge:
1 Route the power and Ethernet cables through the large opening in the cradle.
Figure 4 shows a cable being routed under the cradle.
Figure 4 Routing Cable Under the Cradle
2 Screw the cradle to a wall,
Deciding Where to Place the Bridge
Figure 5
as shown in
.
11
Advertisement
Table of Contents
