Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Related Manuals for Planet VIP-321
Summary of Contents for Planet VIP-321
- Page 1 DECT VoIP Phone VIP-321 Quick Installation Guide...
- Page 2 Overview This quick installation guide describes the objectives; organization and basic installation of the PLANET VIP-321 SIP DECT VoIP Phone, and explains how to establish your first voice over IP communication via PLANET product. Also, this guide shows you how to find additional information on related products and services.
-
Page 3: Table Of Contents
Table of Contents Preparation before beginning administration on the VIP-321 ....5 Physical Interfaces ..............5 Administration Interface ............8 Web configuration access: ............8 Network Interface quick configurations ........9 Installing Batteries into the Handset ..........10 Charging the Handset ...............11 Voice communication samples ............12... -
Page 4: Document Organization
Document Objectives This guide provides physical installation, network configurations, and Internet access establishment information for the PLANET DECT VoIP Phone. Document Organization This guide is organized as follows: 1 Preparation before beginning administration on PLANET DECT VoIP Phone 2 Administration interface... -
Page 5: Preparation Before Beginning Administration On The Vip-321
Preparation before beginning administration on the VIP-321 Physical Interfaces VIP-321: DECT VoIP Phone (2 x RJ-45, 1 x RJ-11) Front Panel of VIP-321 Rear Panel of VIP-321... - Page 6 Physical Interfaces Description RJ-45 connector, to maintain the existing network structure, connected directly to the xDSL/Cable modem through straight CAT-5 cable RJ-45 connector, for Internet access, connected directly to Switch/Hub, through straight CAT-5 cable. RESET Reset to the factory default setting RJ-11 connector, connected directly to the PSTN analog line.
- Page 7 Top view LED function: LAN LED VoIP LED 1 / 2 WAN LED LED and Button Description An active LED indicates either Handset has been In use LED hanged off or Incoming call is ongoing PWR LED A solid LED indicates PWR works normally Press this button (1~9 seconds) to enable the PAGE / DECT PAGE function.
-
Page 8: Administration Interface
The VIP-321 provides GUI (Web based, Graphical User Interface) for machine management and administration. Web configuration access: To start VIP-321 web configuration, you must have one of these web browsers installed on computer for management ● Microsoft Internet Explorer 6.0 or higher with Java support Default LAN IP address of DECT VoIP Phone is 192.168.0.1. -
Page 9: Network Interface Quick Configurations
Network Interface quick configurations Execute your web browser, and insert the WAN IP address (default: 172.16.0.1) of VIP-321 in the address bar. After logging on machine with username / password (default: root / not password), browse to “Network” -->“WAN settings” configuration menu:... -
Page 10: Installing Batteries Into The Handset
Installing Batteries into the Handset You must install three AAA Ni/MH batteries (included in the package) into the VIP-321 handset and charge them in the base for 15 hours or more before you can use your new VIP-321 Cordless IP Telephone. -
Page 11: Charging The Handset
6. Allow the batteries to charge for 15 hours or more before using the Handset to insure a proper first time charge. Charging the Handset Before you use the Handset for the first time, you should fully charge the new batteries for 15 hours or more. -
Page 12: Voice Communication Samples
In this section, we’ll lead you step by step to establish your first voice communication via keypad and web browsers operations. Peer to Peer (P2P) mode STEP 1: Assuming there are two VIP-321 in the network the WAN IP address are 172.16.0.1 and 172.16.0.2 VIP-321-A... -
Page 13: Intercom Mode
If you connected more than one handset to a base (you can connect up to 5 handsets to the same base), you can have a conversation between two people using two different handsets. DECT Phone are registering to the base already of the some VIP-321. VIP-321 Test the scenario: 1. -
Page 14: Sip Proxy Mode
■ VIP-321-B WAN IP address: 172.16.0.1 WAN IP address: 172.16.0.2 Line Number: 100 Line Number: 200 STEP 1: Log in IPX-2000 and create two testing accounts/password: 100 / 123 (for VIP-321-A), and 200 / 123 (for VIP-321-B) for the voice calls. - Page 15 STEP 2: Please log in VIP-321-A via web browser, browse to the SIP settings menu and select the Service Domain configuration menu. In the setting page, please insert the account/ password information obtained from your service provider (in this sample, we’re using PLANET IPX-2000 as the SIP Proxy...
-
Page 16: Quick Reference In Cd-Rom Guide
Quick reference in CD-ROM guide This guide is used to help you startup your DECT VoIP Phone settings. It is also recommended to check the user manual CD-ROM for more details like the “Web Setup”, and how to set the device back to default value.
Need help?
Do you have a question about the VIP-321 and is the answer not in the manual?
Questions and answers