Table of Contents
Advertisement
Configuring the PCs
Configuring Windows 95 or Windows 98 for IP Networking
All PCs must have an Ethernet adapter card installed and TCP/IP as their
protocol. TCP/IP installation must be done manually.
To configure Windows 95 or Windows 98 for IP networking:
•
Select the network properties from the Windows Control Panel.
Find your Ethernet adapter, TCP/IP protocol, and Client for Microsoft
Networks. If these do not exist, you must add them.
To add an Ethernet adapter:
a. Click on Add.
b. Select Adapter.
c. Click on Add (again).
d. Select the manufacturer and model for the Ethernet adapter.
e. Click on OK.
To add TCP/IP:
a. Click on Add.
b. Click on Protocol.
c. Click on Add (again).
d. Select Microsoft.
e. Select TCP/IP.
f.
Click on OK.
To add a Client for Microsoft Networks:
a. Click on Add.
b. Click on Client.
c. Click on Add (again).
d. Select Microsoft.
e. Select Client for Microsoft Networks.
f.
Click on OK.
Restart your PC after making these changes.
Configuring TCP/IP Properties
NETGEAR recommends that you keep the default settings for the TCP/IP setup
parameters, because your PC is configured to obtain its TCP/IP configuration
information from a DHCP server on the LAN. The Model RT338 router is
shipped preconfigured as a DHCP server and assigns the TCP/IP configuration.
To obtain the configuration information from the router:
1. Turn on power to the router.
Wait at least one minute before continuing to step 2.
2. Reboot each PC on your LAN.
Model RT338 ISDN Router Installation Guide
Advertisement
Table of Contents
