Table of Contents
Advertisement
Start Here
Congratulations on your purchase of a NETGEAR
Router.
This document provides instructions to get you connected to an ISDN Internet
service line using the NETGEAR Model RT338 router and your personal
computer. The document is only a quick reference guide. For more detailed
information about installation and configuration, refer to Model RT338 ISDN
Router Installation Guide included on the Model RT338 Resources CD.
Product Illustration
Front Panel
The front panel of the Model RT338 router contains status LEDs. Refer to the
illustration and table below for descriptions of the LEDs on the front panel of
the router.
Label
Activity
PWR (Power)
On
TEST
Blinking/Off
LAN
LNK/ACT
On
(Link/Activity)
Blinking
100
Off
On
ISDN
D
On
B1
On
B2
On
1 (Phone)
On
2 (Phone)
On
Model RT338 ISDN Router Installation Guide
Front Panel of the Model RT338 Router
LAN LEDs
LAN
ISDN
PWR
TEST
LNK/ACT
100
D
B1
B2
Test LED
ISDN LEDs
Power switch
Description
Power is supplied to the router.
If this LED blinks during initialization and then turns off, the
router is functioning properly.
Link has been detected on the LAN port.
A data packet is being sent or received on the port.
LAN is operating at 10 Mbps.
LAN is operating at 100 Mbps.
Router is synchronized with the attached ISDN line.
ISDN B channel is sending or receiving a call.
ISDN B channel is sending or receiving a call.
An analog device (telephone, fax, or modem) connected to the
Phone 1 port is in use.
An analog device connected to the Phone 2 port is in use.
™
Model RT338 ISDN
Phone LEDs
RT338
MODEL
1
2
9534FA
Advertisement
Table of Contents
