Assembly And Setup; Wall-Mounting Setup Method - Hitachi StarBoard FX-79E1 User Manual

StarBoard FX-79E1/89WE1

1.4 Assembly and Setup

When setting up the board, keep the following in mind.
WARNINGS
Install this product on a vertical and flat surface.
Do not install this product on a slanting surface, ceiling or uneven wall. Otherwise, the
equipment might fall, possibly resulting in injury, or the impact might cause product
failure.
NOTICE
- Select a level and stable position.
- Do not set it up near equipment that might generate electromagnetic waves or
radio frequencies, such as radio transmitters, televisions, copying machines or air
conditioners.
- Avoid locations that are dusty, that are subject to extremely high or low
temperatures or humidity, or that are exposed to direct sunlight.

1.4.1 Wall-Mounting Setup Method

WARNINGS
Keep the wall material in mind when installing.
Installing the board on to the wall in a way that does not suite the wall material, may
result in the board falling off the wall causing injuries or damage to the board.
Furthermore, wall installation may not be possible depending on the wall. For details,
consult with your dealer.
Keep the wall strength in mind when installing.
Only use this product after confirming that it is securely attached and will not fall.
Furthermore, be sure to install using a wall-mounting bracket capable of supporting a
weight of at least 50 kg.
1-7
Introduction
English