Download Print this page

Advertisement

Installation Manual

75"
(190cm)
Model: HILF75101
75" Interactive LED/LCD
Version 5 (19/9/2015)

Advertisement

   Also See for Hitachi HILF75101

   Related Manuals for Hitachi HILF75101

   Summary of Contents for Hitachi HILF75101

  • Page 1: Installation Manual

    Installation Manual 75” (190cm) Model: HILF75101 75” Interactive LED/LCD Version 5 (19/9/2015)

  • Page 2

    QUICK SETUP GUIDE For further information, see the user manual. Please contact HITACHI directly if you have questions on the use of the touch monitor after reading the Installation Manual and User Manual. Important: Please read the precautions, safety instructions and this installation manual carefully before installing the touch monitor.

  • Page 3

    Moving and Carrying Notice Moving Notice: Moving the monitor requires at least four people. If not, it may drop and a serious injury may result. Carrying Notice: This monitor is heavy; please follow the instructions below when you are ready to carry the monitor. Failure to do, it may cause injury.

  • Page 4

    Do not place monitors on unstable shelves or surfaces. They could collapse and cause damage. Only install the unit on vertical, stable and level surfaces. Don‘t place objects on the touch monitor. • If the touch monitor is covered or the vents are blocked, the monitor could overheat and cause a fire. •...

  • Page 5

    Install the bracket at a minimum distance of 10 cm from other objects / walls on either side. Only attach to vertical walls. 2. Package contents Packing list Item Q’ty 1. Interactive monitor 2. Carton 3. Bottom cushion 4. Top cushion 5.

  • Page 6

    3. Description OSD Keypad Input/Output Description OSD Keypad Description In/Output Interface OSD 7Key Speaker out ON and OFF Audio line out Menu Display the main on-Screen Menu Audio in (VGA) Source PC, HDMI 1, HDMI 2, HDMI 3, DP DisplayPort Vol + Volume Up HDMI 3...

  • Page 7

    Important Notice 1. The USB cable (5 m) that Hitachi provides in this accessory box is for use of connection to Touch USB at the back. Therefore, in case of connecting USB cable to Touch USB in front, separate USB cable is required and the length of cable is strongly recommended to be less than 3 m to make sure signal intensity of touch sensor work properly.

  • Page 8

    Remote Controller(RCU) Instructions Key Name Description Power ON/OFF. Activates OSD menu of input source selecting. SOURCE Navigates input source. PC RGB HDMI HDMI 1, HDMI 2, HDMI 3. DP Picture mode: Standard, Dynamic, Soft, User. Sound mode: Standard, Flat, Music, Movie. MENU Activates main OSD menu.

  • Page 9

    Display Mode Turning the monitor on 1. Correctly insert the power cord into the monitor and into the power socket. 2. Press the power button on the bottom of monitor or front control panel. Turning the monitor off With the power on, press the power button on the remote or control keypad to place the monitor backside in a standby mode.

  • Page 10

    7. When you complete the nine-point calibration, a conformation window appears. Click done to accept the calibration; click Cancel or do nothing (in which case the calibration window automatically disappears after five seconds) to cancel the calibration. 8. The front B-type USB is for laptop touch. An USB is automatically connected when you connect a laptop.

  • Page 11

    7. Trouble Shooting Before calling service personnel, please check the following chart for a possible cause to the trouble you are experiencing. Perform the adjustments according to the instructions on the “Operating the monitor page”. If the problem you have experienced isn’t described below or you can’t correct the problem, stop using the monitor and call service personnel or your dealer.

Comments to this Manuals

Symbols: 0
Latest comments: