Chapter 6. Expansion Ram Board : Up-S02Mb/04Mb; Chapter 7. In-Line I/F : Up-E10In - Sharp UP-600 Installation Manual

CHAPTER 6. EXPANSION RAM
BOARD :
UP-S02MB/04MB
1) Open the ROM/RAM case
2) Install the two spacers
3) Connect the UP-S02MB/04MB
(CN:303)
NOTE: The UP-S02MB/S04MB has an electric double layer ca-
pacitor (C21). When removing it after using, use caution
not to bring it close to any conductor.
.
on the ROM/RAM PWB unit .
to the ROM/RAM PWB unit
1

CHAPTER 7. IN-LINE I/F : UP-E10IN

1) Remove the top cabinet.
2) Install the spacer on the MAIN PWB
3) Connect the UP-E10IN
4) Fix the UP-E10IN to the spacer
5) Pass the TCP/IP cable
and one core to the following PWB.
UP-E10IN side : CN3, MCR POLE RELAY PWB side
CN504
7) Remove the rear cover.
8) Connect the LAN cable
.
to the MAIN PWB (CN:304).
with a screw .
1
through the two standard holder
9
to the LAN connector .
: