CHAPTER 1. REMOVING THE REAR CHAPTER 2. REMOVING THE TOP COVER CABINET 1. REMOVING THE REAR COVER 1. REMOVING THE TOP CABINET 1) Remove the two screws 1) Open the printer cover 2) Remove the rear cover 2) Lift the pop-up display unit 3) Remove the three screws 2.
4) Slightly lift and slide the top cabinet, and remove the grounding CHAPTER 3. REMOVING THE LCD wire UNIT Note: Do not pull up the top cabinet unit the grounding wire and connector cables from the top Cabinet are re- moved.
5) With a flat-bladed screwdriver, remove the two latches of each CHAPTER 4. REMOVING THE of the LCD rear cabinet and the LCD filer PRINTER UNIT 1. REMOVING THE PRINTER UNIT 1) Remove the top cabinet. 2) Remove the two screws fixed on the printer unit.
2. REPLACING THE STANDARD DRAWER CHAPTER 5. REMOVING THE UNIT STANDARD DRAWER Install the standard drawer unit in the reverse order of removing unit (For KA,KB version) The drawer top has the following holes with which the drawer position can be changed. 1.
CHAPTER 6. EXPANSION RAM CHAPTER 7. IN-LINE I/F : UP-E10IN BOARD : 1) Remove the top cabinet. UP-S02MB/04MB 2) Install the spacer on the MAIN PWB 3) Connect the UP-E10IN to the MAIN PWB (CN:304). 1) Open the ROM/RAM case 4) Fix the UP-E10IN to the spacer with a screw...
9) Install the core to the LAN cable 4) Install the MCR unit to the MCR angle 1 and secure with 2 screws NOTE: Install the ferrite core in a position less than 50 mm from the cabinet. Cabinet Core IN-LINE cable Within 50mm CHAPTER 8.
NOTE: Install the ferrite core in a position less than 50 mm from CHAPTER 10. RS-232 I/F :ER-A5RS , the cabinet. EFT & RS-232 I/F: ER-01EF MCR cable Wire band Wire band 1) Connect the extrnal cables to the I/F board. Cabinet Core <ER-A5RS>...
2) Remove the rear cover. CHAPTER 11. HAND SCANNER : 3) Insert the I/F PWB to the connector of the MAIN PWB ER-A6HS1 4) Fix the I/F angle to the main chassis with two screws 1) Remove the rear cover. 2) Connect the scanner cable to the RS232 CH1 connector.
CHAPTER 12. REMOTE DRAWER : CHAPTER 13. RS232 DEVICES ER-04DW/05DW 1) Remove the bottom cabinet from the standard drawer unit. ( Only for KA/KB version) 2) Connect to the remote drawer cable to the drawer connec- tor of the MAIN PWB (CN:4 or CN5). 3) Fix the earth wire with a screw NOTE: Install the ferrite core in a position less than 10 mm from...
4) Remove the top cabinet 5) Remove the standard clerk cover from the bottom cabinet. 6) Install the clerk cover "B" to the bottom cabinet. 7) Install the clerk switch body to the bottom cabinet. 8) Connect the clerk key cable 8pin to the CKDC PWB (CN8) CHAPTER 15.