GiPodH
Symptom
The file names
• Characters that cannot be displayed are used. This is not a
are not displayed
malfunction. On this unit, characters that cannot be displayed are
properly ("...", etc.).
replaced with a "." (period).
GRemote Control UnitH
Symptom
The set cannot be
• Batteries are worn out. Replace with new batteries.
operated with the
• Operate the remote control unit within a distance of about
remote control unit.
23 ft/7 m from this unit and at an angle of within 30°.
• Remove any obstacle between this unit and the remote control
unit.
• Insert the batteries in the proper direction, checking the q and
w marks.
• The set's remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
• The ZONE SELECT setting is not correct. Press
select the zone to operate.
• The operation mode does not match the settings of the device to
operate. Check the operation mode.
Cause/Solution
Cause/Solution
ZONE SELECT
to
Resetting the microprocessor
Page
Perform this procedure if the display is abnormal or if operations cannot be performed.
–
When the microprocessor is reset, all the settings are reset to their default values.
ON/STANDBY
Page
85
85
85
85
85
1
Turn off the power using
74
2
ON/STANDBY
74
Press
while simultaneously pressing
3
Once the display starts flashing at intervals of about 1 second, release the two
buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
96
8
9
ON/STANDBY
.
8
9
and
.