Getting Started - Denon AVR-1712 Owner's Manual

Basic operation of Setup Wizard
Speaker Connection
Please select the
speaker configuration
to be used.
5.1ch
7.1ch
Others
Move to the item that
5.1ch is the most
you want to configure popular surround
system.
ui
using .
Speaker Connection
5.1ch is selected for speaker
system. Select Yes to confirm.
Move to the item that
Yes
you want to configure
o p
using .
Speaker Connection
Please connect the
speakers.
Location :CENTER
Terminal :CENTER
Press [ENTER] for next
connection.
Enters the selection.
Ready to connect
Setup Wizard
Do you wish to stop
and exit wizard?
You can restart the
setup wizard anytime
using the on screen
Returns to the start of menu.
each setting.
or
Cancels the Setup
Wizard.
SVENSKA NEDERLANDS
1
Insert the main unit power plug into the wall
socket.
To household power outlet
(AC 120 V, 60 Hz)
No
2
ZONE SELECT
Press
(MAIN ZONE).
Switch the zone mode
J
Lights
This remote control can be operated in two separate zones, MAIN
ZONE and ZONE2.
Set the remote control to MAIN ZONE to operate the Setup
Wizard.
Yes
No
When power is switched to standby
X
STANDBY
Press ( ).
GPower indicator status in standby modeH
Normal standby : Off
When "HDMI Control" (vm page 63) is
set to "ON" : Red
NOTE
During power standby, a minimal amount of power is consumed. To
totally cut off the power, remove the power cord from the power
outlet.
ESPAÑOL ITALIANO

Getting Started

3
This remote control is a preset remote control that can be used to
control connected devices.
4
Power cord
to switch the zone mode to J
5
To start the Setup Wizard again after exiting it, select "Setup
Wizard" in the menu (vm page 47 "Menu map").
FRANÇAIS DEUTSCH
AMP
Press to set the remote control unit to AMP-
operation mode.
Switch the AMP-operation mode
Z
ON
Press ( ) to the this unit.
The power switches on, and the Setup Wizard start screen is
displayed on the television screen.
Power on
Setup Wizard
This wizard assists
1. Language Select
connection and setup
2. Speaker Connection
of receiver step by
step using cursor,
3. Speaker Calibration
enter or return keys
4. Source Setup
on remote.
Press[ENTER]to start.
5. Remote Setup
Start
Complete
ENTER
Press .
Start the Setup Wizard.
Setup Wizard has started.
Please follow the message on screen.
ENGLISH
5