Connecting An Antenna; Connecting A Cd Player; Am Loop Antenna; Fm Indoor Antenna - Denon AVR-1712 Owner's Manual

Connecting an antenna

• Connect the FM antenna or AM loop antenna supplied with the unit
to enjoy listening to radio broadcasts.
• After connecting the antenna and receiving a broadcast signal
(vpage 25 "Listening to FM/AM broadcasts"), fix the antenna
with tape in a position where the noise level becomes minimal.
Direction of broadcasting station

AM loop antenna

(supplied)
q w e
Black
White
AM outdoor
Ground
antenna
n AM loop antenna assembly
1
Put the stand section
through the bottom of the
loop antenna from the
rear and bend it forward.
2
Insert the projecting part
FM outdoor
antenna
into the square hole in
the stand.
75 Ω coaxial
cable
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
FM indoor
antenna
Standing alone
(supplied)
Use the procedure shown above to assemble.
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM
loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
• If the signal has noise interference, connect the ground terminal
(GND) to reduce noise.
• If you are unable to receive a good broadcast signal, we recommend
installing an outdoor antenna. For details, inquire at the retail store
where you purchased the unit.

Connecting a CD player

• You can enjoy CD sound.
• Select the connector to use and connect the device.
Stand
Cables used for connections
Square
hole
Loop
Projecting
antenna Audio cable
part
CD player
Nail, tack, etc.
Set this to change the digital input connector to which the input
source is assigned.
"Input Assign" (vpage 70)
11
Audio cable (sold separately)
L
R
AUDIO
AUDIO
OUT
L R
L R
R
L
in Set as Necessary
L
R