(10)Select the files in step (9) except for the following files, and then upload them by overwriting.
Files not being overwritten
In the case of this unit
. correct_gamma_96.cms
. correct_gamma_100_blackins.cms
. correct_gamma_100_interlace.cms
. correct_gamma_100.cms
. correct_gamma_120_blackins.cms
. correct_gamma_120_interlace.cms
. correct_gamma_120.cms
. 3dlut_panel_distortion.cms
. uniformity.dat
. gamma_temp_120.dat (*1)
. gamma_temp_120_blackins.dat (*1)
. gamma_temp_120_interlace.dat (*1)
. gamma_temp_100.dat (*1)
. gamma_temp_100_blackins.dat (*1)
. gamma_temp_100_interlace.dat (*1)
. gamma_temp_96.dat (*1)
. gamma_temp_coef_120.dat (*1)
. gamma_temp_coef_120_blackins.dat (*1)
. gamma_temp_coef_120_interlace.dat (*1)
. gamma_temp_coef_100.dat (*1)
. gamma_temp_coef_100_blackins.dat (*1)
. gamma_temp_coef_100_interlace.dat (*1)
. gamma_temp_coef_96.dat (*1)
. correct_panel_primarycolors_bvm_smptec.dat (*1)
. correct_panel_primarycolors_bvm_ebu.dat (*1)
. correct_panel_primarycolors_itu709.dat (*1)
. correct_panel_primarycolors_dcine.dat (*1)
. correct_panel_primarycolors_wide.dat (*1)
. correct_panel_primarycolors_f2335.dat (*1)
In the case of controller
. serialnumber.id
(*1): Files added from Ver.1.2.
(11)Turn the power off and on again and check that the system is restarted.
n
If the system does not restart normally, it needs to be checked in the factory.
BVM-L230
1-47