Indoor Unit Control - Mitsubishi PK12FK Instruction Manual

2. INDOOR UNIT CONTROL

2-1 COOL operation
CENTRALLY CONTROLLED
POWER
ON/OFF
ON
DRY
MODE SELECT F A N COOL/DRY
FAN COOL
SET
CHECK 81
TENPERATURE WARMER COOLER
SET TEMP F
TIMER OFF
12
AUTO STOP TIMER MODE HOURS
HR
AUTO START
LOW HIGH
FAN SPEED LOW/HIGH
AIR
SWING
UP/DOWN
DISCHARGE
88
F
AUTO RETURN
CHECK TEST RUN
CHECK TEST RUN
(PK12/18/24/30/36FK)
SWING
F
DRY COOL
TIMER OFF TIMER CLOCK AUTO AUTO
FAN
FAN CHECK SET TEMP. START STOP
SPEED
AUTO
RETURN
MODE TIMER ON/OFF CLOCK/TIMER FAN SPEED AIR DISCHARGE FILTER
AIR SWEEP
SET TEMP. TIMER SET
REMOTE CONTROLLER
PK12/18/24/30/36FK
(
PK18/24/30/36FK
2
<COOL operation time chart>
Operation starts by
P O W E R b u t t o n
ON.
ON
Thermostat
OFF
ON
Indoor fan
OFF
ON
Auto vane
OFF
ON
OFF
Compressor
w1 Even if the room temperature rise above the set temperature during this period, the compressor will not start until this peri-
od has ended.
<How to operate>
1 Press POWER ON/OFF button.
2 Press COOL / DRY button to set operation mode to Cool.
NOTE: "Cool" and "DRY" are alternately displayed each time COOL / DRY but-
3 To set desired temperature, press WARMER or COOLER button.
NOTE: Set temperature changes by 2°F in the range 66~86°F, each time
STOP
<How to operate>
1 Press POWER ON/OFF button.
2 Press the MODE button to display COOL.
3 Press the SET TEMP. button to set the desired temperature.
NOTE: Set temperature changes 2°F when the SET TEMP. button is pressed
CHECK
TEST RUN
)
1
Room temperature
becomes equal to
set temperature.
LOW or HIGH
Minimum 3 minutes
ton is pressed.
WARMER or COOLER button is pressed.
one time.
Cooling 65 to 87°F.
Room temperature
rises above set
temperature.
LOW or HIGH
w1
OC196A-32
Operation stops by
P O W E R b u t t o n
OFF.