Mitsubishi PK12FK Instruction Manual page 35

2-2 DRY operation
CENTRALLY CONTROLLED
POWER
ON/OFF
ON
DRY
MODE SELECT F A N COOL/DRY
FAN COOL
SET
CHECK
81
TENPERATURE WARMER COOLER
SET TEMP F
TIMER OFF
12
TIMER MODE HOURS
AUTO STOP
HR
AUTO START
LOW HIGH FAN SPEED LOW/HIGH
AIR
SWING
UP/DOWN
DISCHARGE
88 F
AUTO RETURN
CHECK TEST RUN
CHECK TEST RUN
(PK12/18/24/30/36FK)
SWING F
DRY COOL TIMER OFF TIMER CLOCK AUTO AUTO
FAN FAN
CHECK SET TEMP. START STOP
SPEED
AUTO
RETURN
MODE TIMER ON/OFF CLOCK/TIMER FAN SPEED AIR DISCHARGE FILTER
AIR SWEEP
SET TEMP. TIMER SET
REMOTE CONTROLLER
PK12/18/24/30/36FK
(
PK18/24/30/36FK
2
<DRY operation time chart>
Operation starts by
P O W E R b u t t o n
ON.
ON
OFF
Thermostat
ON
Indoor fan OFF
ON
Auto vane
OFF
ON
Compressor
OFF
w1 Even if the room temperature rises above the set temperature during this period, the compressor will not start until this
period has ended.
<How to operate>
1 Press POWER ON/OFF button.
2 Press the COOL / DRY button to set operation mode to "DRY".
NOTE: "Cool" and "DRY" are alternately displayed each time COOL / DRY button
is pressed.
3 To set desired temperature, press WARMER or COOLER button.
NOTE: Set temperature changes by 2°F in the range 66~86°F, each time
WARMER or COOLER button is pressed.
STOP
<How to operate>
1 Press POWER ON/OFF button.
2 Press the MODE button to display "DRY"
3 Press the SET TEMP. button to set the desired temperature.
NOTE: The set temperature changes 2°F when the SET TEMP. button is pressed
one time.
Dry 65 to 87°F
CHECK
TEST RUN
)
1
Room temperature
becomes equal to
set temperature.
DRY MODE
OC196A-35
Room temperature
rises above set
temperature.
Minimum 3 minutes w1
Operation stops by
P O W E R b u t t o n
OFF.
DRY MODE