Seat 2007 Cordoba Owner's Manual page 204

202 If and when
Removing and fitting the wheel
For removal and fitting the wheel, the following tasks must be
completed.
Change the wheel as described below after loosening the wheel
bolts and raising the vehicle with the jack.
Removing a wheel
– Unscrew the bolts using the hexagonal tool in the handle of the
screwdriver (vehicle tool) and place them on a clean surface
⇒ fig.
136.
Fitting a wheel
– Screw in the wheel bolts and tighten them lightly using the
hexagonal socket in the screwdriver handle.
The wheel bolts should be clean and turn easily. Before fitting the spare
wheel, inspect the condition of the wheel and hub mounting surfaces. These
surfaces must be clean before fitting the wheel.
The hexagonal socket in the screwdriver handle makes it easier to turn the
wheel bolts when they are loose. The reversible screwdriver blade should be
removed when the tool is used for this purpose.
If tyres with a specific direction of rotation are fitted, note the direction of
rotation.
Note
Do not use the hexagonal socket in the screwdriver handle to loosen or
tighten the wheel bolts.
Fig. 136 Changing the
wheel: hexagonal socket
in screwdriver handle to
Anti-theft wheel bolts*
turn the wheel bolts after
they have been loosened
A special adapter is required to turn the anti-theft wheel
bolts.
Fig. 137 Anti-theft wheel
bolt