Seat 2007 Cordoba Owner's Manual page 221

– Remove plastic cover
opening and pull in the direction of the arrow.
A ⇒ page 218, fig. 154
– Press the tabs
B
remove lampholder.
– Turn bigger lamp 1/4 turn to left. For the small lamp, rotate and
extract the lamp holder and pull on the lamp.
– Remove lamp and replace.
– Fit the bigger lamp, pressing inwards and turn 1/4 turn to the
right. Place the smaller lamp in casing and press.
– Carefully fit the lampholder in the casing and press until a "clic"
is heard.
– Next replace the cover and press down.
Note
Make sure that when assembling all seals and rubbers are correctly fitted.
Safety First
A ⇒ page 218, fig.
153, insert finger in
A
of the lamp holder and
Operating instructions
Rear lights on frame
Side light 2/ Brake light/ Indicator light
– Open the tailgate.
– Separate the trim from the boot.
A ⇒ fig. 155
– Press the tab
A
remove it.
– Turn bigger lamp 1/4 turn to left. Pull on the small lamp.
– Remove lamp and replace.
– Fit the bigger lamp, pressing inwards and turn 1/4 turn to the
right. Place the smaller lamp in casing and press.
– Position lamp holder towards where the small lamp is housed.
Next press until a "click" is heard.
Tips and Maintenance
If and when
Fig. 155 Rear lights on
frame
to release the lamp holder and
Technical Data
219