Seat 2007 Cordoba Owner's Manual page 60

58 Cockpit
Note
When the vehicle is stationary or travelling at very low speeds, the tempera-
ture displayed may be slightly higher than the actual ambient temperature as
a result of the heat radiated from the engine.
Display field for selector lever position*
The position of the automatic gearbox selector lever is shown on the display
⇒ page 135.
Mileage display or Service Interval Display
Distance display
The upper counter in the display registers the total distance covered by the
vehicle.
The lower counter registers the short journeys. The last digit indicates steps
of 100 metres. The trip recorder counter may be reset by the reset button
⇒ page 52, fig. 32
Service interval display
A service pre-warning will appear in the odometer if a service is due soon. A
spanner symbol appears and the display "Km" with the distance that can be
driven until the next service appointment is due. The display will change after
approximately 10 seconds. A clock symbol appears and the number of days
until the next service appointment is due.
The following message appears on the instrument panel if a service is due:
INSP- Maintenance service
The service message will disappear approximately 20 seconds after the igni-
tion is switched on or the engine is running. This may also be turned off
pressing the short journey counter reset button for more than 0.5 seconds.
The Service Centre who carry out the maintenance service will reset the main-
tenance interval display on completion of the service.
We recommend that the repair and maintenance work only be carried out at
Authorised Service Centres.
The service indicator can also be reset by pressing the trip counter button.
Proceed as follows:
- Switch off ignition.
- Keep "Reset" button on distance counter pressed.
- Connect ignition with the "Reset" button pressed. The fixed mode
display appears.
- Release the reset button and rotate it to the right. The display will return
Fig. 39 Service interval
to the normal mode. The indication has been reset.
display
2)
With "Ignition OFF" the maintenance display remains visible.
A
.
6
2)