Seat 2007 Cordoba Owner's Manual page 194

192 Checking and refilling levels
Tyre service life
The service life of tyres is dependent on tyre pressure, driving
style and fitting.
Wear indicators
The original tyres on your vehicle have 1.6 mm high "tread wear indicators"
⇒ page 192, fig.
there will be six to eight of them evenly spaced around the tyre. Markings on
the tyre sidewall (for instance the letters "TWI" or other symbols) indicate the
positions of the tread wear indicators. The minimum tread depth required by
law is 1.6 mm (measured in the tread grooves next to the tread wear indica-
tors). Worn tyres must be replaced. Different figures may apply in export
countries ⇒
Tyre pressure
Incorrect tyre pressure causes premature wear and could cause tyre blow-out.
For this reason, the tyre pressure should be checked at least once per month
⇒ page 191.
Driving style
Fast cornering, heavy acceleration and hard braking all increase tyre wear.
Fig. 129 Tyre tread wear
Changing wheels around
indicators
If the front tyres are worn considerably more than the rear ones it is advisable
to change them around as shown
last for about the same time.
Wheel balance
The wheels on new vehicles are balanced. However, various factors encoun-
tered in normal driving can cause them to become unbalanced, which results
in steering vibration.
Unbalanced wheels should be rebalanced, as they otherwise cause excessive
wear on steering, suspension and tyres. A wheel must also be rebalanced
when a new tyre is fitted.
Incorrect wheel alignment
Fig. 130 Changing
Incorrect wheel alignment causes excessive tyre wear, impairing the safety of
wheels
the vehicle. If tyres show excessive wear, you should have the wheel align-
ment checked by an Authorised Service Centre.
129, running across the tread. Depending on the make,
.
⇒ page 192, fig.
130. All the tyres will then