Seat 2005 Toledo Owner's Manual page 65

Set speed indicator
When driving at the required speed, enter the speed indicator mode and
A
press the button (Reset), the display remembers the indicated speed. If
A
the indicated speed is exceeded, a warning text is displayed on the screen
and a warning signal sounds.
This may be deactivated by pressing the button
The speed may be altered using the rocker switch
within 5 seconds of the initial memory value.
Ø km/h - Average speed
The average speed will be shown after a distance of approximately 100
metres has been travelled. Dashes will appear in the display until that time.
The display will be updated every 5 seconds whilst the vehicle is in motion.
km - Distance travelled
The display shows the distance travelled since the ignition was switched on.
The maximum display value in both memories is 9999 km. The memory will
automatically be deleted once this value has been reached.

km - Fuel range
The fuel range is calculated using the figures for tank content and current fuel
consumption. It shows how far the vehicle can travel using the same condi-
tions as a reference.
Ø litre/100km - Average fuel consumption
The average fuel consumption will be shown
distance of approximately 100 metres has been travelled. Dashes will appear
in the display until that time. The display will be updated every 5 seconds
whilst the vehicle is in motion. The amount of fuel used will not be shown.
6)
Depending on the model version, the message on the screen may vary and may be
represented by flashing of the speed indication or by a speed message.
Safety First
A
(Reset).
A
A
in steps of 5 km/h
B
⇒ page 62, fig. 42
after a
Operating instructions
ltr/100km or ltr/hr - Current fuel consumption
The display will show the current fuel consumption in litre/km whilst the
vehicle is in motion or in litre/hour when the vehicle is in a stationary position
6)
with the engine running.
Using this display you can see how your driving style affects fuel consump-
tion ⇒ page 191.
Ambient temperature display
The measurement margin extends from -45°C to +58°C. At temperatures
lower than +4°C, an "ice crystal symbol" is displayed and a "warning" sounds
if the vehicle is moving at more than 20 km/h (ice warning). This symbol will
flash for about 10 seconds and remains lit until the exterior temperature rises
above +4°C or 6°C if it was already lit.
WARNING
There could be black ice on the road surface even if the "snowflake symbol"
is not shown. You should, for this reason, not rely exclusively on this
display - Risk of accident!
Note
When the vehicle is stationary or travelling at very low speeds, the tempera-
ture displayed may be slightly higher than the actual ambient temperature as
a result of the heat radiated from the engine.
Warning or information text in the display
Faults are shown in the display with warning lamps and
warning/information reports.
The system runs a check on certain components and functions when the igni-
tion is switched on and while the vehicle is moving. Functional faults are indi-
Tips and Maintenance
Cockpit
Technical Data
63