Seat 2005 Toledo Owner's Manual page 118

116 Lights and visibility
Note
•
The battery will run down if the hazard warning lights are left on for a long
time, even if the ignition is switched off.
•
The use of the hazard warning lights described here is subject to the rele-
vant statutory requirements.
Turn signal and main beam headlight lever
The turn signal and main beam lever also operates the
parking lights and the headlight flasher.
The turn signal and main beam headlight lever has the following
functions:
Switching on the turn signals
– Move the lever all the way up
all the way down
Signalling a lane change
– Push the lever up
resistance and then release the lever. The turn signal will flash
several times. The corresponding warning lamp will also flash.
Switching main beam on and off
– Turn the light switch to position
– Press the lever forward
beams.
– Pull the lever back towards you to switch the main beam head-
lights off again.
Headlight flasher
– Pull the lever towards the steering wheel
flasher.
Switching on parking lights
Fig. 78 Turn signal and
– Switch off the ignition and remove the key from the lock.
main beam headlight
lever
– Move the lever up or down to turn on the right or left-hand
parking lights respectively.
⇒ fig. 78 A
to indicate right, and
1
A
to indicate left.
2
A A
or down to the point where you incur
1 2

.
⇒ fig. 78 A
to switch on the main
3
A
to operate the
4