Section C: Other Commands - GTCO CalComp BIT PAD TWO DATA User Manual

When the data tablet is in Remote Request and Increment modes, regardless of

whether the increment has been satisfied or not, the actual position where the
stylus or cursor is when the data tablet receives the remote trigger is reported
position.
If Point or Remote Request modes are set by switch rather than by command, the

Report Rate, also set by switch, is valid. Consequently, the Report Rate has priority
over buttons or remote triggers.

Section C: Other Commands

Resolution
Command:
Resolution is the smallest distance or movement that the data tablet can distinguish. It's a
measure of precision and is expressed in lines per inch (lpi) or lines per millimeter (lpmm).
NOTE: The data format and coordinate mode both play a role in which resolutions are valid
for the entire tablet.
Switch Setting:
Bit Pad Two 26