GTCO CalComp Accutab VI Quick Start Manual

Contents

Verify that your AccuTab package includes the following:
AccuTab VI digitizing tablet

16-button high accuracy, illuminated

cursor
USB cable

Universal mounting brackets

Optional Equipment
RS-232 cable with 9-pin connector for

serial connection
Power supply – required only for a

serial installation
Transducer (corded or cordless pen,

4-button or 16-button cursor)
NOTE: Some digitizing applications (typically, non-Windows CAD applications where the
tablet is used solely as a digitizer with no mouse functions) may not require the use of the
TabletWorks software. To configure AccuTab VI for use with a third-party application,
please refer to the installation instructions in the AccuTab VI User's Guide, where you will
find a complete list of vendor configuration settings.
NOTE: If your digitizing tablet came with a TabletWorks CD, install the software FIRST, and
then setup the hardware connections for USB (or the optional serial), following the
instructions below.

Software Configuration

Software drivers provide the communication bridge between your software application and
AccuTab VI. The GTCO CalComp by Turning Technologies-supplied TabletWorks CD
supports reduced functionality Wintab and TabCon-compatible applications. If you are not
sure about your application's driver requirements, contact your application vendor.
CD with drivers and diagnostics

(varies with configuration)
User's guide

Registration card


Plan holder
 Accessory tray
 Table feet

Manual lift/manual tilt pedestal