Table of Contents
Advertisement
1
IMPORTANT NOTES
This product may only be put into operation by an installation organization trained by the manufacturer.
This product may only be operated by adult persons, duly acquainted with the way the product is controlled and
duly acquainted also with these Instructions. If you adhere to the below mentioned principles, the product will
serve you reliably to your full satisfaction.
1)
It is prohibited to intervene in any way in the structure or electrical installation of products. Having the
equipment been disconnected from the electric network, the power supply cord has to be plugged from
the mains outlet.
2)
It is prohibited to use inflammable liquids for ignition.
3)
No inflammable materials may be stored on the boiler, neither may they be stored within the distance of
1,500 mm from the boiler (except for operating metal fuel bin).
4)
In order to preserve long-term service life of the boiler body, it is not recommended to operate the boiler
frequently under the temperature of 55°C, if the boiler is not protected with a primary circuit. The
temperature of 55°C should be considered as the minimum temperature.
5)
The check how the boiler is filled with fuel is only visual. Any verification with touch is prohibited as it
may result in injury.
6)
Never open door of the boiler if there is a ignition process.
7)
The door of the boiler has to be always tightly closed. If you´ll perform any check, open the door
carefully to prevent from getting jeopardized by gathered products of combustion or to prevent any
sparks flying out from the boiler from being the cause of any accident. Open the door slowly in order to
get the combustion chamber aerated towards the chimney. This procedure has to be adhered to when
the ash is being removed from the ash pan's space.
8)
If any work which generates inflammable vapours takes place in the boiler room (glueing the floor, etc.),
the boiler has to be out of operation and the fire has to be burnt out in the boiler.
9)
Having the heating season been finished, clean the boiler thoroughly as per the chapter 7 - Maintenance.
Products of combustion stuck to the walls of the exchanger may act corrosively for the whole period of
time when the boiler will be out of operation. If the burner is not cleaned, this may have effect on faulty
combustion. We recommend to hire a specialized company to perform this work.
10) If you work on or near to the mechanically movable parts (fuel feeder, etc.), ensure safe disconnection of
the equipment from electric voltage. There is a risk of injury.
11) You should always operate the boiler only under parameters and in harmony with recommendations
given in these instructions for installation and operation. If the boiler works in the AUTO mode and if
there is a failure of current, the boiler will start operation again with the electric firing programme (if this
programme has been installed) after the delivery of electric current is restored.
12) The manufacturer does not assume any liability for errors and subsequent damage caused by unskilled
operation of the equipment or by infringement of principles given in these instructions for installation and
operation or by infringement of generally binding standards and regulations or by using inadequate fuel.
13) If the boiler is moved or otherwise handled with, safety regulations which apply to handling with heavy
loads have to be adhered to.
14) It is prohibited to place heavy loads on jacketing boiler and to step on it. It is recommended to remove
the protective foil after all the building and installation work has been completely finished.
15) External ashtray has to be firmly connected to a boiler fitting while in the operation. Cover of this ashtray
has to be tightly closed. There could be a dangerous escape of combustion gases into a boiler room.
Automatic boiler for wood pellets
5
Advertisement
Table of Contents
