Changing Domain Id - NEC SIGMABLADE N8406-019 User Manual

Changing Domain ID

After completing login to the console of the FC Switch Module, change the domain ID of the FC
Switch Module according to the procedure below.
The domain ID is set to 1 when an FC Switch Module is shipped from the factory.
1.
Type "switchdisable" on the console screen to disable the FC Switch Module.
HW060000955:admin> switchdisable
2.
Type "configure" on the console screen.
3.
Type "configure" to display the setting input feature of the FC Switch Module.
Message "Fabric parameters (yes, y, no, n):" appears to ask whether the setting is already provided
or not. Type "y."
HW060000955:admin> configure
Configure...
Fabric parameters (yes, y, no, n): [no] y
4.
On the menu for setting fabric parameters, enter a new value only for parameter "Domain ID" and
press [Enter] for other parameters.
Example of setting change> 1(def) → 2
Fabric parameters (yes, y, no, n): [no] y
Domain: (1..239) [1] 2
R_A_TOV: (4000..120000) [10000]
E_D_TOV: (1000..5000) [2000]
WAN_TOV: (0..30000) [0]
MAX_HOPS: (7..19) [7]
Data field size: (256..2112) [2112]
Sequence Level Switching: (0..1) [0]
Disable Device Probing: (0..1) [0]
Suppress Class F Traffic: (0..1) [0]
Switch PID Format: (1..2) [1]
Per-frame Route Priority: (0..1) [0]
Long Distance Fabric: (0..1) [0]
BB credit: (1..27) [16]
The setting may or may not be changed in no cascade connection. The
setting must be changed in cascade connection.
Setting at shipment from factory
Change the domain ID when the FC Switch Module is installed.
Changing the domain ID after starting the operation may cause a
system fault to occur.
Disabling the FC Switch Module makes it impossible for the FC Switch
Module to communicate with all fibre channel devices connected to it.
Any commands used on the switch console should be specified with
lowercase letters.
- 122 -