Table of Contents
Advertisement
Miscellaneous
The following describes the method of changing the names of several zone objects created or
expunging or copying objects.
After modification by using a relevant command, confirm that the
modification is done normally by using the "cfgshow" command.
After a command is executed, run the cfgsave command to register the new
settings resulting from the change to be registered.
1.
Change the name of an object created already
Use the "zoneobjectrename" command.
Using the "zoneobjectrename" command allows a zone object name to be changed.
Format of "zoneobjectrename" command
zoneobjectrename "objectName" , "newName" <enter>
(1) objectName:
Specify an existing object name to be changed with it enclosed with double quotation marks (").
(2) newName:
Specify the object name after the modification with it enclosed with double quotation marks (").
2.
Expunge an object.
Use the "zoneobjectexpunge" command.
Using the "zoneobjectexpunge" command allows a specified object to be expunged.
Format of "zoneobjectexpunge" command
zoneobjectexpunge "objectName" <enter>
(1) objectName:
Specify an existing object name to be expunged with it enclosed with double quotation marks
(").
3.
Copy an object already created
Use the "zoneobjectcopy" command.
Using the "zoneobjectcopy" command allows a zone object to be copied.
Format of "zoneobjectcopy" command
zoneobjectcopy "objectName" , "newName" <enter>
(1) objectName:
Specify an existing object name to be copied with it enclosed with double quotation marks (").
(2) newName:
Specify the name of the copied object with it enclosed with double quotation marks (").
(1)
(2)
(1)
(1)
(2)
- 140 -
Advertisement
Table of Contents
