NEC SIGMABLADE N8406-019 User Manual page 47

Fc switch module
Table of Contents

Advertisement

2.
According to the User's Guide of the Blade Enclosure (SIGMABLADE), remove the dummy module
or blank cover on the switch module slot into which the FC Switch Module will be inserted.
3.
Unlock the stopper of the ejector on the FC Switch Module to unlatch the ejector.
4.
According to the User's Guide of the Blade Enclosure (SIGMABLADE), install the FC Switch
Module in the Blade Enclosure (SIGMABLADE).
For the procedure of removing a dummy module or blank cover from the
switch module slot of the Blade Enclosure (SIGMABLADE), refer to the
User's Guide attached to Blade Enclosure (SIGMABLADE).
Press the stopper lightly in the right direction to unlock the stopper. Then the
ejector is unlatched.
Push the FC Switch Module lightly to insert its connector into a mating
connector on the Blade Enclosure (SIGMABLADE).
- 47 -

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sigmablade n8406-020

Table of Contents