Appendix: Fc Switch Module Setting Features; Changing Password - NEC SIGMABLADE N8406-019 User Manual

Appendix: FC Switch Module Setting Features

To use FC Switch Modules, you should login to the console to provide proper setting for the FC Switch
Modules. The appendix describes the settings required to use the FC Switch Modules.

Changing Password

After completing login to the console of the FC Switch Module, change the password of the FC Switch
Module according to the procedure below. (You may or may not change the password.)
1.
Type "passwd" on the console screen.
2.
Messages such as those shown below appear. According to the messages, enter the old and new
passwords. Reenter the new password.
WH040000363:admin> passwd
Changing password for admin
Enter old password:
Enter new password:
Re-type new password:
passwd: all authentication tokens updated successfully
Saving password to stable storage.
Password saved to stable storage successfully.
WH040000363:admin>
Set the internal features of the FC Switch Module after reading this guide
carefully to be familiar with the features.
Some setting change for the FC Switch Module may have bad influences on
the system being operated. Examine changing information sufficiently before
setting change.
Any commands used on the switch console should be specified with
lowercase letters.
The new password is made effective at the next login.
The password should consist of 8 - 40 alphanumeric characters.
Be careful not to forget the new password. If you forget, proper maintenance
is required. Contact your service representative.
- 114 -