Connecting The Ua888 System To A Sound System - Shure ua888 User Manual

Connecting the UA888 System to a Sound System

The UA888 Networking System can be integrated into an existing Shure UHF wireless microphone system
without changing the original equipment configuration. Simply connect the 25-pin D Network Interface con-
nector on the rear panel of each U4 Receiver to one of the 25-pin D connectors on the rear panel of the UA888
Interface Module, using the supplied cable. A typical sound system incorporating the UA888 Networking Sys-
tem is shown in Figure 7.
NOTE: If the connection between the UA888 Interface Module and the computer or a receiver is broken, the
computer will display an error message. If this happens, check all connections and restart the UA888 program.
TO RECEIVER 1
TO RECEIVER 2
TO RECEIVER 3
TO RECEIVER 4
AC
POWER
TRANSMITTER 1
TRANSMITTER 2
TRANSMITTER 3
TRANSMITTER 4
MIXER DC POWER SUPPLY
AC
POWER
UA888 INTERFACE MODULE
ANTENNA B IN ANTENNA A IN
RECEIVER 1
AUDIO OUT
RECEIVER 2
AUDIO OUT
RECEIVER 3
AUDIO OUT
RECEIVER 4
AUDIO OUT
DC POWER IN
TYPICAL SOUND SYSTEM WITH UA888 NETWORKING SYSTEM INSTALLED
RS-232
UA840A
ANTENNA DISTRIBUTION
SYSTEM (OPTIONAL)
SHURE
DFR11EQ #1
MIXER
FIGURE 7
– 6 –
SHURE
DFR11EQ #2
SHURE LINK CABLE
POWER AMPLIFIER
LOUDSPEAKERS
ENGLISH
IBM PC
AC
POWER
AC
POWER