Scanning For Uhf Frequencies - Shure ua888 User Manual

3. Click on the arrow next to the "Walk Around Time" field and scroll to the length of time the test is to run
(maximum setting is 1 hour).
NOTE: To determine the time of any point on the graph, simply move the cursor to the point and click on it.
The time will be displayed in a pop up window.
4. Click on the "Start" button to begin plotting. Take note of any "dead" areas in the performing area and make
sure both antennas are functioning properly. You may also consider changing antenna position or relocat-
ing remote antennas to optimize system performance.
5. Click on the "Stop" button to stop testing at any time. To restart testing, click on the "Start" button again.
6. When the plot is completed, click on the "Close" button to return to the main monitor window.

Scanning for UHF Frequencies

The UHF Scanner maps rf signals present within the bandwidth of a particular receiver throughout the per-
forming area. If necessary, the UHF transmitters and receivers can then be reprogrammed for open frequen-
cies. This ensures interference-free operation. To activate the UHF Scanner function, proceed as follows:
1. Click on the UHF Scanner heading in the main menu bar and highlight "Start," as shown in Figure 26. Then
release the mouse button.
"WALK AROUND" PLOTTER WINDOW
FIGURE 25
SELECTING THE UHF SCANNER FUNCTION
FIGURE 26
– 14 –
ENGLISH