Settings In Memory; Store A Contact In Memory; Make A Call From Memory - Kenwood DPX-5000BT Instruction Manual

BLUETOOTH®

Settings in memory

Store a contact in memory

You can store up to 6 contacts into the number buttons
(1 to 6).
1 Press to enter Bluetooth mode.
2 Turn the volume knob to select [CALL HISTORY], [PHONE
BOOK], or [NUMBER DIAL], then press the knob.
3
Turn the volume knob to select a contact or enter a
phone number.
If a contact is selected, press the volume knob to show the
phone number.
4
Press and hold one of the number buttons (1 to 6).
"STORED" appears when the contact is stored.
To erase a contact from the preset memory, select [NUMBER
2
DIAL] in step and store a blank number.

Make a call from memory

1
Press to enter Bluetooth mode.
2
Press one of the number buttons (1 to 6).
3
Press the volume knob to call.
"NO MEMORY" appears if there is no contacts stored.
16
Other settings
1 Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select an item (see the following table), then press
the knob.
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4 Press and hold to exit.
To return to the previous setting item, press
BT MODE
PHONE SELECT
Selects the phone or audio device to connect or disconnect.
" * " appears in front of the device name when connected.
• You can only connect a maximum of two Bluetooth phones and one Bluetooth
AUDIO SELECT
audio device at any time.
DEVICE DELETE 1 Turn the volume knob to select a device to delete, then press the knob.
2 Turn the volume knob to select [YES] or [NO], then press the knob.
PIN CODE EDIT Changes the PIN code (up to 6 digits).
(0000) 1 Turn the volume knob to select a number.
2 Press
Repeat steps
3 Press the volume knob to confirm.
RECONNECT ON: The unit automatically reconnect when the last connected Bluetooth device is
within range. ; OFF: Cancels.
AUTO PAIRING ON: The unit automatically pair supported Bluetooth device (iPhone/ iPod touch/
Android device) when it is connected through USB input terminal. Depending
on the operating system of the connected device, this function may not work. ;
OFF: Cancels.
INITIALIZE YES: Initializes all the Bluetooth settings (including stored pairing, phonebook, and
etc.). ; NO: Cancels.
.
to move the entry position.
1 2
and until you finish entering the PIN code.
Default: XX