Raymarine i50 Installation And Operation Instructions Manual page 42

4. From the VMG page, press the Speed button to display the
SOG page:
Note: SOG information is only available if your unit is part
of a SeaTalk or SeaTalk ng
connected.
5. From the SOG page, press the Speed button to display the
Current speed page.
Note: The Maximum speed and Average speed pages are
temporary pages and will time-out after 8 seconds and revert
back to the Current speed page.
Using the log, trip and temperature pages
To cycle through the available log, trip and water temperature pages
follow the steps below.
Trip
1
2
4
Trip
During normal operation:
1. Press the Trip button to display the Log page.
2. Press the Trip button to display the Trip page.
3. From the Trip page:
i. Press the Trip button to display the Water temperature
page, or
ii. Press and hold the Reset button for 3 seconds to reset the
trip reading to zero.
4. Press the Trip button to display the Log page.
Using the timers
To cycle through and use the count-up and race timer pages follow
the steps below.
Time r
During normal operation:
1. Press the Timer button to cycle through the available timers.
2. Press the Reset button to start the timer.
3. With the timer running, press the Reset button to pause the timer.
4. With the timer running, press and hold the Reset button for 1
second to reset the timer.
Note: After a race start timer has counted down to zero it will
then start to count up.
42
network which has a suitable GPS
Trip
60 5
55
10
50 3
45 15
40 20
35 25
30
Time r
Setting the race start timer
The race start timers can be set from 1 to 15 minutes.
1
With a race timer displayed
1. Press and hold the Timer and Reset buttons simultaneously to
enter adjust mode.
2. In adjust mode:
i. Use the Reset button to increment the race timer start value,
or
ii. Use the Timer button to decrease the race timer start value.
iii. Press and hold the Timer and Reset buttons simultaneously
to exit adjust mode.
3
Timer buzzer
The Timer buzzer is enabled or disabled during calibration see the
User calibration section.
When using a race timer with the timer buzzer enabled, the buzzer
will:
• Double beep every minute.
Trip
• Beep 3 times at the start of the last 30 seconds.
D12534-1
• Beep once for each of the last 10 seconds.
• Beep for 2 seconds at zero.
Time r
D12535-1
2
Time r
Time r Re s e t
Time r
D12536-1
i50