Mounting; Front Bezel - Raymarine i50 Installation And Operation Instructions Manual

5.2 Mounting

Pre-mounting check
The product is designed to be surface mounted. Before mounting
the unit, ensure you have:
• Selected a suitable location.
• Identified the cable connections and route that the cables will take.
• Detached the front bezel.
• Remove the keypad mat.
Mounting diagram
Mounting instructions
1. Check the selected location for the unit, a clear, flat area with
suitable clearance behind the panel is required.
2. Fix the mounting template supplied with the product, to the
selected location, using masking or self adhesive tape.
3. If possible use an appropriate size hole cutting saw and cut
out the centre hole cut out area as indicated on the mounting
template, or
4. Using a suitable hole cutting saw, make pilot holes in each
corner of the cut out area and using a jigsaw cut along the inside
edge of the cut out line.
5. Ensure that the unit fits into the removed area and then file
around the cut edge until smooth.
6. Drill any required holes as indicated on the mounting template
for the securing screws.
7. Connect the relevant cables to the unit.
8. Peel the backing off of the supplied gasket and place the
adhesive side of the gasket onto the display unit and press firmly
onto the flange.
9. Slide the unit into place and secure using the screws provided.
10. Refit keypad mat and front bezel.
Note: Drill, tap size and tightening torques are dependant upon
the material type and thickness of the mounting surface.
Note: The supplied gasket provides a seal between the unit and
a suitably flat and stiff mounting surface or binnacle. The gasket
should be used in all installations. It may also be necessary to
use a marine-grade sealant if the mounting surface or binnacle is
not entirely flat and stiff or has a rough surface finish.
Location and mounting

5.3 Front bezel

Removing the front bezel
1
3
D12379-1
Note: Use care when removing the bezel. Do not use any tools
to lever the bezel, doing so may cause damage.
1. Using your fingers pull the bezel away from the unit at the top
and side, as shown in 2.
The bezel will start to come away from the unit at the top and
side.
2. Now pull the bezel away from the unit on the opposite side, as
shown in 3.
The bezel will now come free from the unit, as shown in 4.
2
4
D12372-1
27