IBM L40 SX Quick Reference page 158

#E.3.1 Installing the Large Pointer Program for OS/2
#To install this program, follow the steps below.
#1. Insert the backup copy of the Reference Diskette into the drive.
#2. At the OS/2 prompt, type:
# A:\LRGPTR2 /style /C:\L40SXUT
# and press Enter.
# Note: To select white large pointer, specify 1 for style.
# black large pointer, specify 2 for style.
#3. Using a non-formatting text editor, in the CONFIG.SYS file, add
# C:\L40SXUT to change the LIBPATH command line to read:
# LIBPATH=C:\L40SXUT;C:\OS2\DLL;. . .
#4. Remove the backup copy of the Reference Diskette from the drive.
#5. Shut down then restart OS/2.
# The pointer you selected is displayed.
#+--- Changing the Pointer Style -----------------------------------------+
¦
#¦ To change the pointer style from the once installed type to the other
#¦ type, do the following.
¦
#¦ 1. Delete C:\L40SXUT; from the LIBPATH command line of the CONFIG.SYS ¦
#¦ file.
¦
#¦ 2. Shut down then restart OS/2.
¦
#¦ 3. Perform again the procedures for installing the large pointer
#¦ program.
¦
+------------------------------------------------------------------------+
PS/2 Model L40 SX Quick Reference
Installing the Large Pointer Program for OS/2
¦ Copyright IBM Corp. 1991
E.3.1 - 1
To select
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦