IBM L40 SX Quick Reference page 48

|3.5.1.1 Entering Suspend Mode
|The computer enters suspend mode when one of the following occurs.
| Closing the display
| PICTURE 73
@ Do not open the display until you hear:
@ - One beep sounds for suspend mode
@ - Two beeps sound for partial suspend mode.
@ Mode," see page 3.5.1.2.
| Issuing the PS2 OFF command in the Set features program
| Setting the System power off after option to XX minutes
| Detecting battery-low condition.
| Detecting temperature outside the operating range, approximately 5°C
| through 35°C (41°F through 95°F).
|Note: To again enter suspend mode immediately after resume mode:
| 1. Make sure that the computer has returned to resume mode (one
| beep).
| 2. Wait 10 seconds.
| 3. Close the display.
| If you do not follow the above instructions, you cannot know which
| mode the computer is in.
| display without waiting for resume mode to appear, you could find
| the computer is in resume mode even though the display is closed.
PS/2 Model L40 SX Quick Reference
Entering Suspend Mode
For "Partial Suspend
For more information, see page 2.5.
If you have opened and then closed the
¦ Copyright IBM Corp. 1991
3.5.1.1 - 1