IBM L40 SX Quick Reference page 126

@D.1.1 Installing the Power Management Device Driver for OS/2
@If you installed the OS/2 operating system, do the following to install
@the power management device driver program for it.
@Note: Make sure that the DOS compatibility box has been configured.
@1. Insert the backup copy of the Reference Diskette into the diskette
@ drive.
$2. At the prompt on the DOS compatibility box, type A:UINSTALL and press
$ Enter.
$ The following screen appears.
+-------------------------------------------------------------------------
¦
$ ¦
¦
$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
$ ¦
$ ¦
$ ¦ Enter the installation SOURCE drive letter, the drive that the program
$ ¦ installs FROM:
$ ¦
$ ¦ Source Drive ... [ A ]
$ ¦
$ ¦ Enter F1=Help
$ ¦ ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
¦
$3. Press Enter twice.
$ The screen for selection appears.
$4. Using Down Arrow ( ) or Up Arrow ( ) select Install OS/2 Power
$ Management Device Driver.
$ the screen.
$5. Remove the backup copy of the Reference Diskette from the diskette
$ drive.
@+--- IDLE.EXE -----------------------------------------------------------+
¦
@¦ If IDLE.EXE has been installed and IDLE.EXE is specified in
@¦ STARTUP.CMD to start whenever the system starts, do the following.
¦
@¦ 1. Modify STARTUP.CMD so that IDLE.EXE will not start even though the ¦
@¦ system starts.
¦
@¦ 2. Restart the system.
¦
@¦ 3. Reinstall the power management device driver program for OS/2.
¦
+------------------------------------------------------------------------+
@Note: Utility programs are available under OS/2.
@ Program" in topic E.3 and "Hot Key Program" in topic E.4.
PS/2 Model L40 SX Quick Reference
Installing the Power Management Device Driver for OS/2
Installation Options
Installation Source Drive
F3=Exit
Press Enter. Follow the instructions on
¦ Copyright IBM Corp. 1991
D.1.1 - 1
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
See "Large Pointer