Ink Ribbon Installation - Mitsubishi Electric CP-D90DW Operation Manual

BEFORE OPERATION
After installing the print paper, install the ink cassette into this unit.
Before installing the ink cassette into this unit, load the ink ribbon in the ink cassette.
• Place the ink cassette on a flat surface, when loading the ink ribbon.
• Select a place that is free of dust when loading the ink ribbon. Dust or dirt settling on the ink ribbon results in poor
print quality.
• Make sure that the shafts of the ink ribbon fit into the ink cassette firmly.
Load the ink ribbon in the ink cassette as shown below.
Make sure to load it in the correct position.
3
1
Shaft
Ink ribbon
Make sure to set the ink ribbon roller to the ditches firmly.
Turn the shaft to eliminate any slack.
Place the ink cassette containing the ink ribbon in the
position as shown in the illustration.
To insert the ink cassette, align the protrusions on both sides of the
cassette with the right and left guides inside the printing unit and slide it in
a slanting direction.
Mount the ink cassette to the back firmly by holding the handle.
• Do not touch the thermal head. Fingerprints or dust on the
thermal head will degrade the print quality.
Do not touch the thermal head right after printing because it is
extremely hot. Otherwise you may get burned or injured.
Note that the thermal head is quite sensitive to static electricity.
When you touch the thermal head while carrying static electricity
on your body, the thermal head may be damaged.

INK RIBBON INSTALLATION

NOTE
4 3
Ditch
1
2
Handle
Ink cassette
NOTE
CAUTION
NOTE
4
2
Handle
Protrusion
Guides
13