Panasonic CS-ME10DTEG Service Manual page 85

8.4.1.12. ON Timer Control
ON timer can be set using remote control, the unit with timer set will start operate earlier than the setting time. This is to provide
a comfortable environment when reaching the set ON time.
60 minutes before the set time, indoor (at fan speed of Lo-) and outdoor fan motor start operate for 30 seconds to determine the
indoor intake air temperature and outdoor air temperature in order to judge the operation starting time.
From the above judgment, the decided operation will start operate earlier than the set time as shown below.
8.4.1.13. OFF Timer Control
OFF timer can be set using remote control, the unit with timer set will stop operate at set time.
8.4.1.14. Auto Restart Control
1. When the power supply is cut off during the operation of air conditioner, the compressor will re-operate within three to four
minutes (there are 10 patterns between 2 minutes 58 seconds and 3 minutes 52 seconds to be selected randomly) after power
supply resumes.
2. This type of control is not applicable during ON/OFF Timer setting.
8.4.1.15. Indication Panel
LED
Color
Light ON
Light OFF
Note:
• If POWER LED is blinking, the possible operations of the unit are Hot Start, during Deice operation, operation mode
judgment, or delay ON timer sampling.
• If timer LED is blinking, there is an abnormality operation occurs.
8.4.1.16. Auto Operation Switch
1. When the switch is pressed between 0 to 5 seconds, Auto Mode operation starts to function.
2. When the switch is pressed between 5 to 8 seconds, the unit is forced to operate in Cooling Mode.
3. When the switch is pressed between 8 to 11 seconds, the unit will enter forced Heating Mode standby. Press timer decrement
button for 5s for the unit to operate in Heating Mode.
POWER TIMER
Green Orange
Operation ON Timer Setting ON
Operation OFF Timer Setting OFF
QUIET POWERFUL
Orange
Quiet Mode ON Powerful Mode ON Auto Air Swing ON
Quiet Mode OFF Powerful Mode OFF Auto Air Swing OFF
85
AIR SWING
Orange Orange