Channel Selector - Teac AG-D8000 Owner's Manual

Balancing relative volume between
speakers during playback of DVD
1
(During playback of DVD,) press the CHANNEL
SELECTOR button.
Each time the CHANNEL SELECTOR button is pressed, the
channel is changed as follows:
Front Left Center
(DD L or DTS L)
If the balance has already been set using the test tone
function, you don't have to change the setting of
speakers (FL, C, FR, RR, RL, SW).
If you want to change the LFE level for Dolby Digital or DTS,
press the CHANNEL SELECTOR button repeatedly until "DD L
(Dolby Digital LFE)" or "DTS L (DTS LFE)" appears on the
display.
(LFE: Low Frequency Effect)
< "DD L" or "DTS L" appears only when the LFE signal of Dolby
Digital or DTS is input from the selected DIGITAL IN terminal.
< A speaker set to "None" or "No" will not appear on the
display.
< When STEREO is selected, or when the SPEAKER button is set
to off, only the front speakers will appear on the display.
Speaker Configuration (Channel Selector)
Front Right Rear Right
Subwoofer Rear Left
2
Within 2 seconds, press the CHANNEL LEVEL buttons (or
the ADJUST buttons of the main unit) to change the
level.
< The level of speakers can be adjusted in 1 dB steps from –15
dB to +15 dB.
< The LFE level can be adjusted in 1 dB steps from –10 dB to 0
dB. The default setting is 0 dB. Lower the LFE level if
necessary.
1 2
Repeat step and to change other settings.
When all the configurations have been finished, leave the unit
idle for 2 seconds to exit the Channel Select mode.
15