Tuner - Teac AG-D8000 Owner's Manual

< Make sure the antennas have been connected (see page 3).
1
Select TUNER by pressing the AUDIO button (or the
TUNER button of the remote control unit).
2
Select AM or FM by pressing the BAND button.
< If the BAND button is pressed while the source other than
TUNER was selected, the source will be switched to TUNER
automatically.
3
If "PRESET" indicator is lit, press the TUNING MODE
button to select the manual tuning mode.
The "PRESET" indicator disappears from the display.
This button is used to change the tuning mode.
24

Tuner

4 Select the station you want to listen to (auto selection).
Hold down the TUNING/PRESET button for more than 0.5
seconds.
When a station is tuned in, the tuning process will stop
automatically.
If you want to stop the tuning process, press the
TUNING/PRESET button.
Selecting stations which cannot be tuned automatically
(manual selection)
When the TUNING/PRESET button is pressed momentarily (0.5
second or less), the frequency changes by a fixed step.
FM: 50 kHz steps
AM: 9 kHz steps
Press the TUNING/PRESET button repeatedly until the station
you want to listen to is found.
< "TUNED" is displayed when a broadcast is correctly tuned in.
FM MODE Button
Pressing this button alternates between Stereo mode and
Mono mode.
Stereo:
FM stereo broadcasts are received in stereo and the "ST"
indicator lights in the display.
Mono:
To compensate for weak FM stereo reception, select this
mode. Reception will now be forced monaural, reducing
unwanted noise.