You can store up to 30 stations.
Manual Memory Presetting
1
Tune in a station you want to listen to (see steps
4
of page 24).
2
Press the MEMORY button.
3
While the "MEM" indicator is blinking, select a preset
channel to store the station using the TUNING/PRESET
buttons, and then press the MEMORY button.
You can also use the numeric buttons of the remote control
unit to select a preset channel.
Example:
To select channel No. 2:
To select channel No. 3:
To select channel No. 16:
To select channel No. 30:
To select channel No.16 for example, press "1", and within 2
seconds press "6".
To select channel No.30, simply press "0". (When storing
stations, even if you press "3" and "0", Channel No.3 will be
selected instead of 30.)
When using the numeric buttons, the station is stored
automatically without pressing the MEMORY button.
To store more stations, repeat steps
Preset Tuning
1
to
1
to
3
.
How to select preset stations
1
If "PRESET" indicator isn't lit, press the TUNING MODE
button to select the preset tuning mode.
< When using the remote control unit, you can skip this step.
2
Press the TUNING/PRESET buttons repeatedly until the
desired preset station is found.
< You can also use the numeric buttons to select a preset
channel.
Scanning preset stations
Press the PRESET SCAN button of the remote control unit.
Preset stations stored in memory are scanned at 5 seconds
intervals.
When the station you want to listen to is found, press the
PRESET SCAN button again to stop scanning.
25