Starting A Firmware Update - Gigaset SL910 Manual

Starting a firmware update

Prerequisite: The base is connected to the Internet and is in idle status.
Starting the firmware update manually
¤
In the Settings menu (
¤
Scroll to Firmware Update.
Firmware.
If a new version of the base firmware is available, message New firmware available
- Update? is displayed.
¤
Press Yes to confirm.
Please note
u
The firmware update can take up to six minutes, depending on the quality of
your DSL connection.
u
During the update, the registered handsets temporarily lose their connec-
tion to the base.
Setting the automatic firmware update
¤
In the Settings menu (
¤
Scroll to Firmware Update.
next to Automatic Check.
If the function is activated, the base will check daily whether a new firmware ver-
sion is available. If this is the case, you will receive the message Start download?.
¤
Press Yes to confirm.
If you answer the prompt with No, the message will not be displayed again until the
next firmware version is available. You can perform the firmware update manually
¢
( page 91).
Please note
If the phone is not connected to the Internet at the time the check for new
firmware is carried out (e.g., no router connection), then the check will be car-
ried out as soon as the phone is reconnected to the Internet.
¢
page 24), touch [
Touch the corresponding '.
¤
Enter the system PIN and confirm with è.
¤
¢
page 24), touch [
¤
Activate/deactivate the function with the button
Updating the base firmware
Ê
System].
¤
Touch Update
Ê
System].
91