Gigaset SL910 Manual page 90

Hide thumbs Also See for SL910:
Table of Contents

Advertisement

Service Centres (Midde East)
"
Base connection lost - Searching for base ...
¥
1. The handset is outside the range of the base.
Move the handset closer to the base.
¥
2. The base is not activated.
Check the base power adapter (
¥
3. The base's range is reduced because Eco Mode is activated.
Deactivate Eco Mode (
the base.
"
Handset not registered to any base
The handset has not yet been registered or was de-registered due to the registration of an
additional handset (more than six DECT registrations).
¥
Register the handset again (
The handset does not ring.
¥
1. The ringtone is deactivated.
Activate the ringtone (
¥
2. The phone does not ring if the caller has withheld his number.
Activate the ringtone for unknown calls (
You cannot hear a ringtone/dialling tone from the fixed line.
The phone cord supplied has not been used or has been replaced by a new cord with the
¥
wrong pin connections.
Please always use the phone cord supplied or ensure that the pin connections are correct
when purchasing from a retailer (
The connection always terminates after approx. 30 seconds.
¥
Repeater activated/deactivated (
Activate/deactivate the handset (
Error tone sounds after system PIN prompt.
¥
You have entered the wrong system PIN.
Reset the system PIN to 0000 (
Forgotten system PIN.
¥
Reset the system PIN to 0000 (
The other party cannot hear you.
¥
The handset is "muted".
Unmute the microphone (
The number of the caller is not displayed although CLIP has been set.
¥
Calling Line Identification is not enabled.
The caller should ask the network provider to enable Calling Line Identification (CLI).
You hear an error tone when keying an input.
Action has failed/invalid input.
¥
Repeat the process.
Read the display and refer to the user guide if necessary.
You cannot listen to messages on the network mailbox.
¥
Your PABX is set to pulse dialling.
Set your PABX to tone dialling.
88
"
flashes on the display.
¢
page 12).
¢
page 60) or reduce the distance between the handset and
"
flashes in the display.
¢
page 66).
¢
page 76).
¢
page 75).
¢
page 97).
¢
¢
page 77).
page 21).
¢
page 77).
¢
page 77).
¢
page 37).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sl910a

Table of Contents