John Lewis JLBIWD 1403 Instruction Manual page 8

An incorrect option selection has been made:
●
An alarm code
●
9 Start/Pause button
To start the selected programme, press the
Start/Pause button; the green pilot light stops
flashing.
If you have selected a delay time, the countdown will
begin and will be shown on the display.
To interrupt a programme which is running, press
the Start/Pause button: the green pilot light starts
to flash.
To restart the programme from the point at which
it was interrupted, press the Start/Pause button
again.
If an incorrect option is selected, an integrated red
pilot light of the Start/ Pause button flashes 3
times the message Err is displayed for a few
seconds.
Important! You must set the washer-dryer to Pause
before you make any change in the programme in
progress.
10 Door lock light
This pilot light illuminates to indicate that the appliance
starts operating and the door is locked.
It stays on during the whole programme. When this
light goes out, the door can be opened.
This pilot light indicates if the door can be opened:
• Light on: the door cannot be opened.
The appliance is running.
• Light off: the door can be opened.
The washing programme is finished.
When you PAUSE the cycle, it becomes possible to
This is indicated by the
message Err for a few
seconds when a function
incompatible with the
current programme is
selected.
It indicates a fault with the
machine (see the relevant
chapter).
open the door, provided:
• The appliance is not in the heating phase;
• The level of the water is not high;
If all these requirements are met, the Door lock light
goes off and the door can be immediately opened.
11 "Delay start" button
This button makes it possible to delay the starting of
the programme by 30 min - 60 min - 90 min, 2 hours
and then by 1 hour up to a maximum of 20 hours.
The delay you have selected is shown on the display for
about a few seconds; afterwards, the duration of the
programme reappears.
Selecting the delayed start
You must select this option after you have set the
programme and before you press the Start/Pause
button.
• Select the programme and the required options.
• Select the Delay start.
• Press Start/Pause button: the machine starts its
hourly countdown.
The programme will start after the selected delay
has expired.
You can change the delay time at any moment,
before you press the Start/Pause button.
If you have already pressed the Start/Pause button,
and you wish to cancel the delay time, proceed as
follows:
• set the machine to PAUSE by pressing the
Start/Pause button;
• press the Delay start button until the symbol "
is displayed.
• press the Start/Pause button again.
Important!
• The Delay start cannot be used with drain
programme.
Note!
The door will be locked throughout the delay time.
If you need to open the door, you must first set the
washer-dryer to Pause by pressing the Start/Pause
button. When the Door lock light goes off the door can
be immediately opened. After you have closed the door,
press the Start/Pause button again.
8
0'
"