Drying; Autodrying - John Lewis JLBIWD 1403 Instruction Manual

Hold option light and the Door lock light remain lit to
indicate that the water must be drained and the door is
locked.
To drain or to spin see paragraph Rinse hold on
page 13. Turn the programme selector dial to Reset
Off to switch the machine off.
Remove the laundry from the washer dryer.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining

Drying

The recommended loads size is 3 kg for cottons and
linen, and 2 kg for synthetics.
Important! It is also possible to dry up to 4 kg of
cotton items (see the drying time table).
The water tap must be open and the drain hose
must be positioned in the sink or connected to
the drain pipe.
1. Load the laundry.
2. Turn the programme selector dial to Cotton Dry
or Synthetic Dry programme.
3. Press the Drying Time button until the time you
want appears on the display (see drying time table).
Every time you press this button the drying time
increases by 5 mins. (Note: The programme time
will automatically increase by a few minutes, this is
quite normal).
4. Press the Start/Pause button to start the
programme. After the programme has started, the
time remaining is updated every minute.
5. At the end of the programme, the buzzer sounds
0.00
and three blinking «
The Door lock light is on to indicate that the door
is locked.
The last 10 minutes of the drying cycle correspond
to an anti-crease phase. During this time the door
is locked and the display keeps showing three
0.00
flashing zeros « ». Important: If you wish to
open the door before or during the anti-crease
phase or to interrupt it, press any button or turn
the programme selector dial to any programme
position (except Off), the door can be opened
after a few minutes (Door lock light is off).
» appear on the display.
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the machine.
6. Turn the selector dial to Off position to switch the
machine off and remove the laundry.

AUTODRYING

For NON-STOP programmes, the recommended load
size is 3 kg for cotton and 2 kg for synthetics. Note! It
is also possible also to dryup to 4 kg of cotton items
(see the drying time table).
Do not use a dosing device/ball when carrying
out a washing & drying programme.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning the selector dial
to the selected washing programme/fabric.
4. Select the required options by pressing the relevant
buttons. Important! If possible, do not select a
spin speed lower than that proposed by the appli-
ance to avoid a too long drying time therefore
saving energy. In any case the reduction of the spin
speed is only possible after selecting drying. The
lowest values you can select are the following: 900
r.p.m. for cottons and 700 r.p.m. for synthetics.
5. Select the drying time by pressing Drying Time
button. The display shows the whole duration of
the washing and the selected drying cycle.
6. Start the programme by pressing Start/Pause
button. After the programme has started, the time
remaining is updated every minute.
7. At the end of the programme turn the programme
selector dial to Off to switch the machine off.
8. Remove the laundry.
11