John Lewis JLBIWD 1403 Instruction Manual page 7

• Select the spin programme : reduce the spin speed by
pressing the relevant button and then press the
Start/Pause button.
The water is emptied out and the laundry is spun at
the selected spin speed.
Important !
Before selecting the drain or spin programmes, the
selector dial must be positioned on Off (cancelling).
The Rinse hold option CANNOT be selected for the
automatic «Washing & Drying» programme.
STAIN: select this button if you wish to add a stain
phase to the washing of heavily soiled laundry. Pour a
stain removing detergent into the compartment
marked
.
This function is available for programmes with a
temperature of 40° or higher.
The washing time will be prolonged by a few minutes.
For the compatibility of this option with the washing
cycles, refer to the Chapter «Washing programmes»
5 "Extra rinse" button
This option can be selected with all programmes,
except the Wool programmes . The machine adds
some rinses in cotton, synthetics and delicates
programmes.
This option is recommended for people who are
allergic to detergents, and areas where the water is
very soft.
6 "Drying time" button
If you wish to carry out a timed programme push the
button until the drying time you want appears in the
display according to the fabrics (cotton or synthetics)
you have to dry.
For Cottons you can select a drying time from 10 to
250 minutes.
For Synthetics you can select a drying time from 10
to 130 minutes.
Every time you press this button the drying time
increases by 5 mins.
7 "Quick" button
This option can be used for lightly soiled garments in
order to obtain a good washing programme in a short
time. The washing time will be reduced according to
the type of fabric and the selected temperature.
We recommend that you reduce the load to 3 kg for
Cottons and to 1.5 Kg for Synthetics and Delicates.
For the compatibility of this option with the washing
cycles, refer to the Chapter «Washing programmes».
8 Display (Wash time)
The following pieces of information are shown on the
display:
• Duration of washing programme in hours and
minutes, after you have selected a programme (for
example 2.05).
The washer-dryer has stopped with water in
●
the tub (Rinse hold option): this is indicated by a
flashing zero. The Start/Pause light goes out but the
Door lock pilot light is still on. The door cannot be
opened.
will be enabled. Only the green Start/Pause light flashes
to indicate that the appliance has to be switched off.
Delay start: a time value indicated in hours and
●
selected by pressing the relevant button.
Start/Pause button, the countdown is updated every
hour, and, for the last hour, every minute.
Selection of drying time in minutes.
●
45
7
While the programme is
running (after you have
pressed the Start/Pause
button), the displayed time
value decreases by one unit
every minute.
If your laundry is not
removed within 10 minutes
after the programme has
finished, all pilot lights and
the display switch off and
the energy saving system
The delay time (20 hours
max) is displayed for a few
seconds, then the duration
of the selected programme
reappears.
After you have pressed the
After starting the
programme, the remaining
time is updated every
minute.