John Lewis JLBIWD 1403 Instruction Manual page 20

Symptom
The machine vibrates when
spinning
The door will not open
Spinning starts late or the
machine does not spin
The machine makes an unusual
noise
No water is visible in the drum
The machine does not dry or
does not dry properly
Solution
●
The internal packing has not been removed.
●
The machine is in contact with the wall or furniture.
●
The machine is not level and stable (check diagonally).
●
The washing load is badly distributed in the drum.
●
Maybe there is very little laundry in the drum.
●
The water level is above the bottom edge of the door.
●
The machine is heating the water or drying the laundry.
●
The drum is turning.
●
The Door lock light is still on.
●
The electronic balance control device has cut in because the laundry is
not evenly distributed in the drum. The laundry is redistributed by
reverse rotation of the drum. This may happen several times before
the unbalance disappears and normal spinning can resume. If, after few
minutes, the laundry is still not evenly distributed in the drum, the
machine will not spin. In this case, redistribute the load manually and
select the spin programme.
●
The load is too small. Add more items, redistribute the load manually
and then select the spinning programme.
●
The machine is fitted with a type of motor which makes an unusual
noise compared with other traditional motors. This new motor
ensures a softer start and more even distribution of the laundry in the
drum when spinning, as well as increased stability of the machine.
●
Machines based on modern technology operate very economically
using very little water without affecting performance.
●
The drying time or degree of drying has not been selected
●
The water tap is not turned on (
●
The drain filter is clogged (
●
The machine is overloaded
●
The selected drying time was not suitable for the laundry.
20
E10 )
E20
)