Connecting The Electrical Power To The Hob - Dometic CC09 Operating Manual

CC09, CCK09, CC11
7 Connecting the electrical power to the
hob
WARNING! Beware of injury
!
Connecting the hob may only be carried out by a qualified techni-
cian.
The following information is intended for technicians who are famil-
iar with the guidelines and safety precautions.
Observe the following safety instructions for the electrical connections:
NOTICE!
A
 If you need to feed cables through metal walls or any other walls
with sharp edges, use ducts or tubes.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Fasten the cables securely.
 Do not pull on the cables.
 Lay the cables so that they cannot be tripped over or damaged.
➤ Make sure that the operating voltage of the device corresponds to the on-
board electricity supply by referring to the type plate on the hob.
➤ Connect the device according to fig. 5, page 3 to the 12 V
electronics.
Use a two-wire cable with flat sockets 6.3 x 0.8 mm (1).
The power circuit must be protected with a 5 A fuse (not included in
delivery scope).
➤ Secure the cable with a clip.
EN

Connecting the electrical power to the hob

on-board
g
13