Cutting Capacity; Prior To Operation - Black & Decker CS355 Manual

•
Tighten the fence bolts (P) to lock the fence
(E).
•
Remove the lock chain (A) and return the
arm to its upper rest position.
Adjusting the spark deflector
(fig. 1)
•
Loosen the screw (B).
•
Set the spark deflector (C) as appropriate.
•
Tighten the screw (B).
Use
Warning: Always observe the safety instructions
and applicable regulations.
Warning: Do not apply excessive pressure to
the tool.
Warning: Avoid overloading. Should the tool
become hot, let it run a few minutes under no
load condition.

Cutting capacity

The wide vise opening and high pivot point
provide cutting capacity for many large pieces.
Use the cutting capacity chart to determine total
maximum size of cuts that can be made with a
new wheel.
Caution: Certain large, circular or irregularly
shaped objects may require additional holding
means if they cannot be held securely in vise.
Maximum cutting capacity
Note: Capacity shown on chart assumes no
wheel wear and optimum fence position.
Workpiece
shape
90º Cutting A = 4-7/8" A = 4-1/2"
Angle (125mm) (115mm) (115mm x 130mm) (115mm x 137mm)
45º Cutting A= 4-1/2" A = 3-13/16" 4-1/2" x 3-13/16"
Angle (115mm) (98mm)

Prior to operation:

•
Install the appropriate cutting disc. Do not
use excessively worn discs. The maximum
rotation speed of the tool must not exceed
that of the cutting disc.
•
Make sure the disc rotates in the direction of
the arrows on the accessory and the tool.
•
Secure the workpiece.
•
Always set the spark deflector correctly.
Switching on and off (fig. 1)
The on/off trigger switch (N) is mounted in the
operating handle.
•
To run the tool, press the on/off trigger switch
(N).
•
Keep the on/off switch depressed while
performing the operation.
•
To stop the tool, release the trigger switch
(N).
Warning: Do not switch the tool on or off when
under load.
Warning: To prevent unauthorized use of tool,
install a standard padlock (not included) into the
padlock hole (O) located in the trigger switch.
Warning! Do not cut magnesium.
ENGLISH
4-1/2" x 5-1/8" A = 4-1/2" x 5-3/8"
4" x 7-5/8"
(115mm x 130mm)
3" x 7-3/8"
(115mm x 130mm)
A = 3-13/16"
4-1/8" x 3-3/4" 3-3/4"
(105mm x 95mm) (95mm)
11